SKIA High Performance Non-shrink Grout for Large Volume (GROUT 214-11), Size 25 kg. Grey

• Special type of ready-mixed cement Provides high compressive strength and does not shrink.
• Suitable for large volume pouring jobs such as
  • Machine base
  • Railway support base
  • Prefabricated concrete pillar base
  • Embedding anchor bolts in concrete (Anchor Bolt)
  • Bridge beam support base
  • Repairing holes in concrete work
• Use grout to adjust the level yourself. Impact resistant and vibration well
• It is liquid and flows well, making it easy to pour. No shrinkage occurs (Non-Shrinkage)
• Has good shape stability Provides high compressive strength Adjustable liquid thickness
• Does not cause bleeding (Bleeding), is not toxic, does not cause rust.
• Packaging size 25 kg.
• gray cement texture

Technical information

• Density (Bulk) : approximately 1.47 kg./liter
• Flowability: Water content 15 %, liquid thickness (J rote) <14 seconds.
• Hardening time: water content 15 %, early ~ 4 : 00, late ~ 6 : 00

Usage rate

• 1 liter of mortar Use approximately 2 kg of cement powder.
• 1 cubic meter uses 75 bags x 25 kg. and 280 liters of water.

Mixing

• Pour SikaGrout®-214-11 TH into a clean mixing container. and there is water that has been weighed or measured to the correct amount. For liquid consistency (J rote at 8 seconds), use 3.75 liters of water (approximately 15% of the weight of SikaGrout®-214-11 TH). Mix using a low speed mixer (not more than 500 rpm) for approximately 3 minutes or until mixture is obtained. that is smooth and homogeneous

Usage

• Pour the ready-mixed cement into the prepared form. You must ensure that there is no Air bubbles are in the grout. Pouring grout under the steel plate must be controlled. Make sure that the pouring pressure is even and continuous. Make sure that the grout mold is well installed and does not leak.

Grouting large cavities or channels

• SikaGrout®-214-11 TH can be mixed with other cementitious materials with sizes of 4-8 mm., 8-16 mm., or 16-32 mm. in ratios from 50-100%, depending on the volume or Size of the hole to be grouted which cement mixed material A rounded shape is more suitable than a coarsely ground type. Using a compressor The vibrating type helps compact the grout well.

Pouring machine base grout

• Sprinkle with water until it is wet and saturated. Be careful not to let water pool in the bolt hole. You should grout the bolt hole area first (Anchor Bolt) and then grout the machine base part next. It must be ensured that the flow of SikaGrout® -214-11 TH is continuous.
• Distance between the anchor bolt and the surrounding concrete surface The average should not be less than 10 mm.

Pouring grout under the steel plate

• Sprinkle with water until it is wet and saturated approximately 24 hours before pouring, but be careful not to let the water flood. Maintain a constant pressure value so that the flow is continuous Use a chain or cable to help. This is to ensure that the grout is poured into the entire cavity and to ensure that there are no air bubbles in the grout.

Note : Product colors shown on the website. There may be differences from the color display settings of each screen.