PLUMB Plastering Mortar for Lightweight Block, 40 KG

• Ready-made plaster Especially for plastering lightweight brick walls. It can be plastered both inside and outside.
• Has good adhesion strength Reduce cracks with special fibers
• Add water-absorbing substances to prevent water loss. Sticky and smooth, easy to plaster.
• Smooth plaster surface made from fine sand grains. Makes the plastered wall surface smoother
• The plaster surface is more insulating than general plaster. 40% reduces the problem of cement buckling.
• Has a higher adhesion value than the standard greater than or equal to 1.35 kg/sq.cm. (German standard greater than or equal to 0.3 kg/sq.cm.)
• Can be used with a plaster sprayer.
• Packaging size 40 kg./bag

Technical information

• Area of use (sq m/bag) : Plaster covers an area of 2.6 sq m at a thickness of 1 cm.

How to use

1. Preparation
   
   • Use a water brush or broom to wipe off all the dust stuck to the wall. Wait for the wall surface to absorb water until it is slightly dry before plastering.
2. Mixing
   
   • Mix 1 bag of plaster with 9.5 -10 liters of water or no more than 2 cans of cement. Mixing the cement requires stirring the cement until it is uniform and not granular.
   • 1 bag of plaster, weighing 40 kilograms, can plaster approximately an area of 2.6-2.8 square meters at a thickness of 1 cm.
3. Mix with machine
   
   • Stirring with a mixer It should take approximately 3-5 minutes to mix, making sure that the cement is uniform and not granular. So the cement was released into the pickup truck. Then leave it for about 5 minutes to let the chemicals break down. Stir again and use putty.
4. Mix by hand
   
   • Stirring by hand (use a shovel to stir) mix thoroughly. Check to see that the cement is not granular and is of the same consistency. Leave it for about 5 minutes to allow the chemicals to break down. Stir again and use putty.
5. Plastering
   
   • Plaster no more than 1.5 cm thick. Apply the plaster by pressing down with a plaster trowel, rolling it thin first and adding plaster to the desired thickness.
6. Plastering concrete structures (columns-beams)
   
   • Preparing the surface of a concrete structure before plastering requires removing the surface of the area that needs to be plastered thoroughly. Leave it for about 1-2 days.
   • Mixing cement for plastering on concrete surfaces Must mix plaster thicker than wall plaster.
   • First layer of plaster Apply a thin layer of plaster about 1-1.5 cm. Wait for the plaster to set and dampen. Then you can add plaster layer by layer to the desired thickness. You can follow the same steps and details as plastering a brick wall. Until the end of every plastering step.

Additional recommendations

• Correct use and mixing of cement according to methods Helps reduce crack problems better.
• After mixing with water, it should be used completely within. 1-1.30 hours
• Contains cement. Can cause irritation if it gets on the skin or in the eyes.
• If it gets into your eyes and there is irritation, rinse with clean water. If you have allergic reactions, you should see a doctor.
• Should be stored in the shade, not wet. Shelf life is 3 months.

Note

• The selling price does not include shipping costs. (In the part of product lifting cost Please contact the after-sales service department. at telephone number 1308)
• The color of the product shown on the website There may be differences from the color display settings of each screen.